EMI MEX
216-535-4848
S2K Commerce - Products Dropdown
Actions
- ${title}
S2K Commerce - Shopping Cart
Actions
- ${title}
S2K Commerce - Order Entry
Actions
- ${title}
7350 Gimatic 2-Jaw Angular Self-Centering Electric Gripper MPBS PNP Sensor included on jaw
Gimatic electric grippers are designed to be used in place of traditional pneumatic components were compressed air circuits could be a liability. They operate in an on/off manner receiving their signal directly from a control panel. There is no programming needed or intermediary control device. An added benefit is the energy savings realized because the motor is only used to actuate the device. The actuator position is maintained by mechanical means when an object is gripped and motor cut off.
A microprocessor and all electronics are integrated into the gripper so that no other external controller is necessary. The microprocessor operates the motor and turns it off with no programming required.
- 150g
- With PNP sensor
- Built in motor drive
- Self–centering jaw system
- 2x16mm Stroke
- 6.2 in-lbf Total gripping force
- T–slot style jaws for heavy loads
- 24 volt DC with on/off signal from PLC
Ideal for DIY end effectors to be used on Collaborative Robots. Compatible with the QC-75 electrical connector. Can also be used with our entire line of electric grippers.
Plate for mounting Mechatronic (Electric) grippers onto a robot with ISO 9409-1-50-4-m6 Interface
Plate for mounting Mechatronic (Electric) grippers onto a robot with ISO 9409-1-50-4-m6 Interface
Allows direct connection from Gimatic 3-pin electric gripper to UR Tool I/O (wrist)