Fixed Angle, Flat to Incline Model KK

• Available with 15°, 30° or 45° discharge angle
• Direct Drive configuration with 1/3 hp AC motor (110V input with 230/60/3 output to motor)
• 4-40 FPM variable speed drive
• No roller chain or sprockets
• Sealed gear reducer
• 12-gauge powder coated steel frame construction
• 50 lbs. maximum load
• Double V-guided, FDA approved, white PVC belt with 1-1/2" high flexible cleats on 18" centers
• 4" high side rails lapped over the conveyor belt with poly-carbonate in-feed flapper
• Bottom slide tray protects cleats
• Leg sets and swivel castors included
• 15' power cord included. Pre-wired ready to run (except poly-phase systems which require some customer wiring)
• Control wiring contained in liquid-tight conduit and connectors
• Units up to 10' length ship fully assembled
• Available Options

Two Ways to Order:

1. Download Conveyor Calculations Sheet pdf.

• Fill in the information in sections C and D—as well as any other information pertinent to your application.
• Submit by Email.

2. Call EMI at 216-535-4848 (Mon.–Fri., 8 a.m.–5 p.m., EST) - please have the following information available:

• The conveyor model
• The belt width
• Determine the in-feed and discharge lengths (in feet): For 6", 9", 12", and 18" belt width Models, the motor is located at the discharge. The “A” dimension infeed length minimum is 2". The “B” dimension discharge length minimum is 2". A + B can not exceed 15'.
  For 24" and 30" wide Models, the motor is located at the in-feed. The “B” dimension discharge length minimum is 2". The “A” dimension infeed length minimum is 2". A + B can not exceed 15'.
• The conveyor in-feed belt height
• Note: Additional widths, lengths, belt speeds, etc. are available.

BW = Belt width.
2' and 3' “B” dimension = 20 to 45° angle adjustment.
4' and 6' “B” dimension = 12 to 45° angle adjustment.
Horsepower determination charts | Leg location and leg count charts