Extruded Aluminum Frame Conveyors, Z-Belt

• Anodized extruded aluminum frame with side channels that accept standard 3/8" hex head bolts/nuts See Detailed Illustration
• 0-60° adjustability from horizontal to incline sections with built-in angle indicator
• Anodized aluminum side rails 4" high, 90° overlapping the belt 1¼" per side
• New heavy-duty powder-coated steel leg sets with 4" locking swivel castors. Extruded aluminum leg sets available.
• 110 Volt 1/3hp AC motor with variable speed standard
• Gear reducer is sealed and permanently lubricated requiring no service
• 4-40 FPM variable speed drive
• Direct drive power transmission
• 50 lb. maximum load
• V-guide belt guidance
• Automatic spring loaded belt tensioning
• Laced, flat PVC belting (blue), FDA approved material
• 210°F belt temperature resistance
• Units up to 20' long are shipped fully assembled

Common Options:

• Extruded Aluminum Conveyor Options
• 2-20 FPM or 7-70 FPM are available at no charge
• Endless belting is available at no charge
• Alternate belting is available on all EA models. View all the options here.
• Side rail extensions for part containment
• Polycarbonate rail covers
• Chilled air or ambient air blowers for part cooling
• Stainless steel discharge chute
• Deionizing blowers to eliminate static electricity and prevent particles from sticking to parts
• Box filling by cycle count or weight
• Alternate motor locations

• *When Ordering: Minimum length of motor frame section is 3'. Minimum length of intermediate and non-motor sections is 2' each. Total combined lengths of all frame sections cannot exceed 15'.

BW = Belt width
Usable belt width measurement and rail options