Z6_EL9QHKG10GPM20IJGE61AK10O0

Error:

Javascript is disabled in this browser. This page requires Javascript. Modify your browser's settings to allow Javascript to execute. See your browser's documentation for specific instructions.

Z7_I8001C80M82D40A3IJJSN11012

S2K Commerce - Products Dropdown

Actions

Z7_I8001C80MOVHE0AP2AJ17A3084

S2K Commerce - Shopping Cart

Actions

0 Items

Z7_EL9QHKG10GPM20IJGE61AK10S5

S2K Commerce - Order Entry

Actions

Home > End-of-Arm Tooling > Sensors / Electrical > Gimatic Teachable Sensors > 7644 Gimatic 5-Wire Teachable C-Slot PNP Sensor

7644 Gimatic 5-Wire Teachable C-Slot PNP Sensor with 2.5m lead and 2 programmable outputs

Item #:PRO SSR4N225G

Available: In Stock

Gimatic PRO-SSR sensors are digital magnetoresistive sensors with 2 programmable output signals: open, closed, and one that detects any position in the middle. The type of output can also be programmed (N.O. or N.C.) whereas type of the sensor (PNP or NPN) is set at the factory and cannot be changed.

70.00

Each

Quantity:

Perfect for sprue applications where sprue sizes can differ and part picking where the part size can change depending on position.
Easy single button programming.
5-Wire, 12/24 Vdc, 0.2 A, PUR cable, 2.5 meters long leads
Ideal for applications where space is limited and multiple output signals are needed, up to 2 positions.
For Gimatic C shaped sensor slots and fixed in place with set screw.
Each output can be independently configured to Normally Open or Normally Closed and is clearly identified by LEDs.
Wide +/- 30mm sensing range (relative to the magnet and the sensor).
Adaptor #7527 is available for combining the single 8-pin M8 into 3x3pin M8 connectors.
To guide you through the process of teaching your PRO sensor, there is a TEACH button, and various LED lights, one for power and one for each output signal: 1, 2, and 3. The output signal LED lights will flash as you cycle through the teaching mode. See the Programming Procedure linked document for further information.