6423 Gimatic Quick Changer Small Size (50mm), EOAT Side

Thin-plate interface to mount EOAT side quick changer to Gimatic, >ASS<, and 80/20 profiles. Fasteners and mounting screws are included.

For horizontal wall mounting and storage of EOAT's

For vertical wall mounting and storage of EOAT's

This quick changer accessory connects electrical signals from the EOAT to the robot. It has 15 pin gold plated SUB D connectors and comes complete with mounting hardware.

I/O Connection Type: 15-pin D-Sub, VGA type Cable.

I/O Connection Type: 15-pin Screw terminal module. Suitable for use with >ASS<, Senvex, and Gimatic Quick Changers. Certain Quick Changers require spacers for the electrical connector, see below.

The lower profile pin design helps avoid damage to contacts. The spring assists in maintaining connection through constant compression and pin geometry. This provides simpler and easier coupling through self-aligning geometry.

I/O Connection Type: 15-pin D-Sub, VGA type Cable.

The lower profile pin design helps avoid damage to contacts. The spring assists in maintaining connection through constant compression and pin geometry. This provides simpler and easier coupling through self-aligning geometry.

I/O Connection Type: 15-pin Spring-Clip terminal module

RFID identification module for automatic recognition of gripping tool composed of the Reader (RAQC) and the Tag (RBQC).

Quick changers assure the EOAT will be perfectly positioned each time it's mounted to the robot. In addition to helping to prevent damage to the mold or the EOAT, this can also greatly reduce the amount of fine-tuning needed upon set up. Using a quick changer that automatically connects air, vacuum and electrical assures that each time the EOAT is mounted, all of the connections will be correct (i.e. primary vacuum, secondary vacuum, primary air, secondary air etc.).