EMI MEX
216-535-4848
S2K Commerce - Products Dropdown
Actions
- ${title}
S2K Commerce - Shopping Cart
Actions
- ${title}
S2K Commerce - Order Entry
Actions
- ${title}
3350 >ASS< Quick Changer with Safety Lock Large Size (150mm), Robot Side
Quick changers assure the EOAT will be perfectly positioned each time it's mounted to the robot. In addition to helping to prevent damage to the mold or the EOAT, this can also greatly reduce the amount of fine-tuning needed upon set up. Using a quick changer that automatically connects air, vacuum and electrical assures that each time the EOAT is mounted, all of the connections will be correct (i.e. primary vacuum, secondary vacuum, primary air, secondary air etc.).
The SWH RV 150 features a safety locking mechanism against unintentional opening. The brass button needs to be pushed-in in order to unlock the quick changer. All air-ports have build-in check valves which turn the air circuit off when the EOAT side is removed.
- 1215g
- Maximum air pressure: 87psi (6 bar)
- 10, G1/4" O.D. air ports
- Includes sensor bracket to monitor locked position, sensor sold separately.
- Reference: 1-020-14-00
SST
Thin-plate interface to mount EOAT side quick changer to Gimatic, >ASS<, and 80/20 profiles. Fasteners and mounting screws are included.
Typically used when the injection molding machine is over 750 tons, this plate is designed to mount large/jumbo >ASS<, Gimatic, and 80/20 four- and six-groove profiles (80mmx40mm) as well as all standard four- and six-groove >ASS<, Gimatic, and 80/20 profiles. It is pre-drilled to mount to the large EOAT quick changer. The counter-bored holes provide flush mounting surfaces on both sides. And it can also be used as a manual mounting plate to the robot.
This anodized aluminum plate can be used as a manual EOAT mounting plate to adapt profiles. It's scored with a center line making it easy to locate holes for mounting to your robot tooling plate.
For horizontal wall mounting and storage of EOAT's
For vertical wall mounting and storage of EOAT's
This centering pin helps the manual centering of heavy EOAT's
This spacer is required for the connection of the electrical interface SWH ES to the quick change system SWH
Quick changers assure the EOAT will be perfectly positioned each time it's mounted to the robot. In addition to helping to prevent damage to the mold or the EOAT, this can also greatly reduce the amount of fine-tuning needed upon set up. Using a quick changer that automatically connects air, vacuum and electrical assures that each time the EOAT is mounted, all of the connections will be correct (i.e. primary vacuum, secondary vacuum, primary air, secondary air etc.).
I/O Connection Type: 15-pin Screw terminal module. Suitable for use with >ASS<, Senvex, and Gimatic Quick Changers. Certain Quick Changers require spacers for the electrical connector, see below.